We are offering a special of the Funk turntable with a Rega RB100 tonearm mounted combined with a New Music Hall Tracker/Goldring Elektra phono cartridge installed.
These are new units and not demos. All for less than the suggested retail of the Funk turntable alone ($859). This is a great opportunity to get an audiophile turntable at a great price
The Funk is equipped with:
•Achroplat (pat pend): Improving on acrylic, it is the perfect Achromatic (non-resonant) support.
•Inverted Sapphire Bearing. Very hard, very highly polished. Seen in the highest performance decks.
•DC Motor drive. Low vibration and optimally matched to the platter's inertia for consistent drive.
•Sorbothane connected feet to isolate critical midband energy from the outside world.
AVReview, December 2005 "It's capable of things that decks costing three or four times as much can only dream of" Jason Kennedy
Read full review of the Funk Firm Funk turntable @ AVReview.co.uk
Music Hall Tracker Specifications:
Frequency Response 20Hz-20kHz±3dB
Channel Balance 2dB @ 1kHz
Channel Separation 20dB @ 1kHz
Sensitivity 5mV±2dB, 1kHz @ 5 cm/sec
Static Compliance 16mm/N
Equivalent tip mass 0.7 mg
Vertical Tracking Angle 26°
Stylus Radius Elliptical .0007” x .0003” (18x7)
Stylus Type Replaceable
Load Resistance 47,000 Ohm
Load Capacitance 150-400pF
Internal Inductance 560 mH
Internal Resistance 700 Ohm
Cartridge Weight 4.2g
Fixing Centre 0.5” (12.7mm)
Playing Weight 1.5-2.0g (1.7g nom.)
Shipping to the continental US shall be by UPS Ground.
